answersLogoWhite

0

Take it to the Land Rover dealer or any rv dealer

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you install a brake controller in a 2003 2500HD Chevrolet?

By following the instructions that came in the box of the new trailer brake controller.


Replacing brake pads in a 2006 range rover sport HSE?

HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER


Why is your range rover stuck in neutral?

its the brake switch censer under the brake peddle itself.


How do you install electric brake controller in 2006 international 4300?

Air over Electric brake controler like Warner P# 1300-80. but be ready to open your wallet. They range from $350-$590 US (2012).


How do you change the brake pads on an 04 land rover range rover?

Take it to HiFlex Engineering S Yorks 01909 568681


How do you change rear brake bulb in range rover sports?

remove old bulb, insert new bulb.


How do you reset brake lights on for 2003 land rover range rover?

THIS VEHICLE THROWS A CODE WHEN ELECTRONIC WEAR SENSOR HITS ROTOR, CAUSING MESSAGE "CHECK BRAKE LINING", AND BRAKE LIGHT TO COME ON. THIS CODE MUST BE CLEARED IN VEHICLES COMPUTER BY OBD II OR EQUIV.


What companies make brake controllers?

Hayes Brake Controller Company is a manufacture that has been designing and building brake controllers for 60 years now. They are easy to install and have a reliable line of electronic trailer brake controllers available.


What are the check lights on a 92 range rover looks like a circle with brackets around it?

Brake pads need to be replaced


Where is the fuse panel on a 1987 range rover that contains fuses for brake lights and horn?

To the right of the heat/air levers


Where is the window relay in a hse 4.6 1997 range rover please?

In the engine compartment, above and behind the brake pump (on the right hand side of a right hand drive Range Rover)... it's located in the fuse box to the rear of the battery.


How do you hook up a brake controller to the brake system of a 1998 Toyota Tacoma 4x4 with CC and ABS?

The connector for the brake controller is under the dashboard on your right close to the driver's foot rest. If you buy the genuine Toyota wiring harness with the connector then it will not take you more than a minute or so to install it as it fits right into the wiring harness that leads away from the brake controller. Make sure that everything is fixed in place and not lose.