Pull out The heater fan switch/knob also interier light can be switched on by pulling out the switch / knob for the lights. Ronnie Lisburn Co Antrim
The led light in the window switch is not replaceable. It is only serviced with the entire switch.
HBL IS ABBREV. FOR HEATED BACK LIGHT, WHICH WOULD BE A REAR WINDOW DEFROSTER FOR A HARD TO WRANGLER. ROBO, 20+ YEARS JEEP/CHRYSLER PARTS MGR.
If the window switch is functioning properly but not lighting up, it could be a faulty LED bulb within the switch. You may need to replace the switch to resolve the issue. Ensure to check the wiring connection as well to rule out any loose connections.
The light switch may not be working because of a faulty connection or wiring issue, even though the light itself is on. It is possible that the switch is not properly controlling the flow of electricity to the light.
The fog light switch on my peugeot 106 is next too the hazard warning switch and the rear window heater switch below the stereo.
If the heater still works the bulb is just burn out. I doubt you can change the light you will have to replace the switch.
Use a test light to see if the motor is getting power. If it is then motor is bad. If it is not getting power "jump" the wires on the switch to see if window will operate, is so switch is bad
If you press the switch and hear the motor running, the the gear kit needs to be replaced. If you do not hear it, look at the dome light and see if it dims when you press the switch. If it does then you have a bad motor.
First you turn on one of the switches and don't enter the room for sometime, till the light inside is heated up. Then switch that light off, and then turn the second one on and enter the room. The one heated up (feel by hand) is the first switch that was turned on, the one glowing is the second switch turned on and the remainder not hot nor light up is the third switch * WHY DOES IT MATTER IF YOU CANT OPEN THE DOOR??
use a continuity tester on the switch itself just hold contacts on tester to contacts on switch and if it reads with a beep or a light your switch is good pending the tester is accurate
Chrysler uses that abbreviation for "electric back light" which is what they call a heated rear window defroster.