answersLogoWhite

0

There is a collar in the front of the transmission ( bellhousing ) that the throw-out bearing slides on when you push the clutch pedal down and let off.

It more then likely has a bad were grove cut into it and throw-out bearing is hanging up on it, so it makes a popping noise. You may even have some springs broken in the pressure plate. Need to remove transmission and clutch assy. Be sure to check piolet

bearing in the back of crankshaft too.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you see that the clutch assemble is damaged?

Some symptoms of a faulty clutch: - when you depress the clutch and press the gas (when changing gears) an used clutch will "slip" (maybe even make noise) and the car will accelerate slower than normal - when the gearbox is in neutral, some vibrations could be felt or some abnormal sounds could be heard


Grinding noise when you let of the gas and the truck rides on its gears?

u gotta use the clutch m8


Why does transmission make clunk noise when sifting gears?

You need to use the clutch and the shifter smoothly together!


What is the grinding noise when you change gears?

It can be the clutch, it doesn't work properly. And check the transmission fluid level. Sad news is that if it's the clutch you will have to replace it as soon as possible.


What are symptoms of bad clutch in manual 5 speed 4 cylinder Toyota?

Difficulty engaging gears and noise when actually engaging


What would cause your SUV to make a high pitch squealing noise when you shift gears?

If it's a manual transmission, it might be the throwout bearing. However, this noise would only occur with the clutch pushed in. If it does it after you let the clutch out then it might just be an accessory belt that needs tightening.


Why would a 1994 Mercury Cougar make a clunking noise when changing gears?

check the u-joints in the drive shaft first


Your vw golf 1.9 diesel is making a clicking noise when you change gears and it seems like its coming from the clutch?

That is your clutch flywheel going, basically you need a whole new clutch system which is very expensive, the clicks will get more loud and more frequent


How do I fix the popping noise in my speakers?

Replace the speakers. Adjust the Fade/Balance and listen to find which speaker is popping. The popping noise is most likely from a broken cone in the speaker


What could be the reason of noise produce when shifting gears and clutch release?

== == If the noise occurs while shifting gears, the gear shift shaft underneath the car could be tapping on the exhaust. This problem is caused by a shifter that has too much play. To fix this, there is a rubber clasp holding the shaft in place, buy a new rubber clasp if the one you have is worn and loose. This is the solution I have found. If the noise occurs while clutch is released, well, then your're on your own!


What would cause a chattering noise to come from your clutch or transmission every time you start your truck after it has been sitting for a while and it also grinds gears occasionally when cold?

Cracks in the clutch disk will cause the noise and a wore syncronizer in will not allow gear to mesh, more so in cold weather.


What is the grinding noise on a megane 2?

It depends on where the grinding noise is coming from. Most of the time the grinding is coming from the brakes and the brake pads need to be replaced. If they've been grinding for a while, the rotors will need to be resurfaced or replaced. Other possibilities for grinding are worn axle bearings, or a problem with the clutch. If the clutch goes out, there will be a grinding noise when you try to shift gears.