0
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
What else can I help you with?
Do you need a lift for 22 rims on a 1998 xj8 jag?
lift kit for 1998 xj8 jag 22" rim
What is the engine oil capacity of a 2001 jaguar xj8?
7 litres
1999 jag Xj8 oil capacity?
about 89 qts
How do you repair a PO174 emisions code?
1199 jag xj8 mas airflow sensor
How do you replace an inner headlight on a 2001 xj8 Jag?
Remove the bulb and simply pull the headlamp out, you need to give it a good yank or get a lever behing the lamp to pry it out, it is just held in by three round plastic gromits that pull free. I have just done this on my 1999 XJ8 so i assume it will be the same.
How do you set the timing on a 1999 jaguar XJ8 engine?
where are thev timing markson a 1999 xj8 jaguar
Where can I fina a Owner's Manual for a 2001 Jaguar XJ8?
ebay
What type of coolant does a 2001 jaguar xj8 use?
Dexcool
Where is the transmission fluid stick on the 2001 xj8 vanden plas?
On the 2001 Jaguar XJ8 Vanden Plas, the transmission fluid dipstick is located near the back of the engine bay, on the passenger side. It is typically a yellow or orange handle, making it easier to identify. To check the transmission fluid level, ensure the engine is running and warm, and then pull out the dipstick, wipe it clean, reinsert it, and check the level.
How do you clear the check engine light on a 2000 XJ8?
To clear the check engine light on a 2000 Jaguar XJ8, you can use an OBD-II scanner to read the trouble codes and then clear them. Simply connect the scanner to the OBD-II port, retrieve the codes, and use the option to erase or clear them. Alternatively, you can disconnect the vehicle's battery for about 15 minutes to reset the engine control module, which may also turn off the check engine light. However, make sure to address any underlying issues that triggered the light to avoid it coming back on.
Where is the coolant drain plug for 2001 jaguar XJ8?
The coolant drain plug for a 2001 Jaguar XJ8 is located on the engine block, typically on the lower side, near the water pump. It can be accessed from underneath the vehicle, so make sure to use caution while working under the car. Always ensure the engine is cool before attempting to drain the coolant, and be prepared to catch any fluid that drains out.
Reset check engine light 98 jaguar xj8?
To reset the check engine light on a 1998 Jaguar XJ8, you can use an OBD-II scanner to clear the trouble codes. Simply connect the scanner to the OBD-II port, turn the ignition to the "On" position without starting the engine, and follow the scanner's instructions to clear the codes. Alternatively, you can disconnect the car's battery for about 15 minutes to reset the system. However, it's essential to address any underlying issues that caused the check engine light to activate before resetting.
