If you have power brakes it may be the vacuum booster. The booster may be going bad, the check valve in the vacuum line or a cracked vacuum line.
Keep firm pressure on the brake pedal and steer towards where you want to go.
You may need to have the brakeline bled (drained of brake fluid) and add new brake fluid while making sure brakeline is air free. This is usually done by pumping the brake until the pedal becomes appropriately firm . Hope this helps .
It is above the brake pedal not under it. Follow the brake pedal bracket all the way up and you will see the brake pedal switch.
Just above the brake pedal, on the mounting bracket that the pedal pivots on.Just above the brake pedal, on the mounting bracket that the pedal pivots on.
to the left of the brake pedal
An Improper WIPE.. will cause a skid Too much pressure on the gas pedal or brake pedal can cause a skid.
There is a brake switch which is actually behind the brake pedal, the fuse would not have blown its more like the brake switch. Easily fixed too.
You could be pressing the brake pedal too hard. Another reason why it may jerk is because the pull brake is engaged.
Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.
well if you are on a bike the pedal is high because your feet need to tuch it.so if your short and you know it then your feet will tuch it.
On the brake pedal bracket under the dash.On the brake pedal bracket under the dash.
It would be the rubber pad that sits on your brake pedal. Unless they were referring to brake pads, which are the pads which enables your vehicle to stop by pressing the brake pedal.