0
What else can I help you with?
How do you repair the temperature control switch on a 1996 Ford Explorer xlt?
Remove the temperature control switch wiring harness. Remove the temperature control switch retaining screws. Reverse the process to install the new temperature control switch.
Does a cylinder head temperature sensor in a ford focus control the fan or does the coolant temperature sensor control it?
A coolant system temperature sensor controls it. : CHILTON calls it the cylinder head temperature sensor. Some after market manufacturers call it the coolant temperature sensor. These are equivalent.
The temperature control module in your 1997 Ford Explorer?
The temperature control module for a 1997 Ford explorer is the unit that controls all of the heat and ac functions. If it is not operating properly, then the heat ac and defrost will work improperly or not at all.
Where is the Idle Air Control valve located on a 1998 Ford Explorer 6-Cylinder 4.0L SOHC?
On most models, the Idle Air Control (IAC) valve is located on the throttle body.
Where is the temperature control sensor on a 1996 Oldsmobile Aurora?
Its located on the back of right cylinder head ...fun too get too.....
What does error code p0125 on a '99 ford explorer mean?
Trouble code P0125 means:Insufficent coolant temperature for closed loop fuel control
On my 2001 ford aerostar minivan why is there a thumping sound in the dash when you put temp control to hot side?
The thumping sound in the dash of your 2001 Ford Aerostar when you set the temperature control to the hot side could be caused by a few issues. It may indicate that the blend door actuator is malfunctioning or that there is debris obstructing the blend door. Additionally, a failing heater core or loose components in the dashboard could also contribute to the noise. Inspecting these components can help identify and resolve the issue.
What is part number 1l2z-19e616-ca for a ford explorer xlt?
I believe it is a blend door actuator. The blend door actuator "blends" hot and cold air enabling you to control the climate control temperature.
What is the thumping noise and vibration coming from my right rear axle on my 99 mercury marquis i already replaced tires wheels brakes rotor and rear axle bearing?
It could be a suspension part such as a control arm. I just had replace the rear control arms on my 1993 Toyota Celica because the bearings in the control arms were worn out. It made a lot of rattling and thumping; when I replaced the arms the sound stopped.
Your 2003 Explorer ABS light is coming on from time to time and the cruise control quit working?
Replace the cruise control deactivater switch which simply screws into the top of the master brake cylinder. Costs less than $20 and everything will run properly again! there is no deactivater switch on the master brake cylinder on a 2003 ford f-250
Why the temperature 20 degrees is marked on the measuring cylinder?
liquid has deferent density at deferent temperature and so deferent volume 20 degree Centigrade is written on measuring mean that this cylinder will give accurate volume at 20 degree centigrade
What all does a master cylinder control on a car?
just the slave cylinder, for your brakes.
