A blinking check engine light in a 2004 Subaru Impreza WRX typically indicates a serious issue, such as a misfire, that can damage the catalytic converter if not addressed immediately. It may be caused by problems like faulty spark plugs, ignition coils, or fuel delivery issues. It's important to have the vehicle diagnosed using an OBD-II scanner to identify the specific trouble codes and address the underlying problem as soon as possible. Continuing to drive the car with a blinking light can lead to more extensive and costly repairs.
Check out the related link for instructions on how to remove the back seat from a Subaru Impreza.
carfax
Clarion. Check this out: http://elrocco.com/integration-of-an-ipod-in-a-2006-subaru-impreza-25i
Yes, along with dozens of other things.
Subaru Impreza WRX is a type of sports car. If you would like to know more information about this car, check Subaru's official website. There's a lot of important information about this car on there.
On a 1997 Subaru Impreza, the reset button for the check engine light is typically located under the dashboard, near the driver's side. It may be a small button or a diagnostic connector that requires a paperclip or similar tool to short the terminals. Consult your owner's manual for specific instructions on resetting the check engine light, as the exact location can vary slightly based on the model.
If the check engine light is blinking that means an engine cylinder misfire has been detected
is the check engine light on? if so it may be the coolant temperature sensor...happened to me...if it doesnt turn over at all try the starter or the battery
The spark plug gap for a 1999 Subaru Impreza typically ranges from 0.028 to 0.032 inches (0.7 to 0.8 mm). It's important to check the owner's manual or a repair guide for the specific engine type, as gaps may vary slightly depending on the engine configuration. Always ensure the gap is set correctly before installation for optimal engine performance.
A noisy fuel pump in a 1995 Subaru Impreza could be a sign of oncoming failure. Check the pump for the source of the noise, and it is probably a good idea to replace it.
I have been told it is because of the Oxygen Sensor .... if you look in the manualit states 'check engine' is related to the electrics. hope this helps
A blinking check engine light means an ignition cylinder misfire has been detected