1996 Ford Countour is because the transmission is overheating usually due to overfilling with Transmission Fluid.
This is not necesarily true. line preasure could be down, torque converter slipping, especially in the ford axod transmisions, they have a short longevity and once that light comes on stop driving it and get it to a tranny shop. this light is equal to an engine check light only for the tranny. However the transmission has no way to shut itself off to prevent damage.
A malfunction has been detected
A flashing over drive off light indicates that a malfunction has been detected with the transmission - get it checked out by a professional as soon as possible
A malfunction has been detected
if the overdrive light is flashing, you have a problem in the transmission you need to take vehicle to a good transmission shop before you need to get towed in
OD stands for Over Drive and it just means that your car is adjusting its actions to save money and gas.
dude flashing o/d means problems to your trans check it out No it doesnt. I own a 90 es250 and the o/d flashes when the car is in o/d. There is a small button on the back of the shifter where you can turn it on and off. You might want to look for this button elsewhere if it is not on your shifter.
On a 1996 Ford Probe : Just below and to the left of the check engine light is the ( O/D OFF light , that indicates that the Over Drive , or top gear of the automatic transaxle / transmission has been switched off ) if the Over Drive has not been switched off and the light stays on or is flashing a problem has been detected Just below and to the right of the check engine light is the air bag readiness light , if the light stays on or is flashing a problem has been detected with the Supplemental Restraint System / air bag
For when he has to haul over-dimension loads.
Problem with the transmission. Seek professional help.Problem with the transmission. Seek professional help.
There is something wrong with it. probally over heated.
The light is flashing probably because the computer isn't receiving a signal from one of the sensors. They are mounted around the center differential and tell the computer whether the rear wheels are spinning at a different speed than the front wheels, which would indicate the need to engage AWD. Check the wiring to ensure there are no breaks, and that the connectors are in good condition. If the light comes on and stays on rather than flashing, pull over and do not drive. The differential or an axle needs gear oil and will be destroyed if it doesn't get it.
If an over the counter drug might affect your ability to drive it will