possible faulty relay
The windshield wipers are not automatic... the lever that controls the wipers have three positions and you will have to pull the lever down to the off position. The position below off is for mist. If you pull the lever to that position and let it go, the lever will go back to the off position.
Turn the wipers off, pull the wiper arm off, and replace it in the correct down position.
The wiper motor has a switch inside of it. When they are turned off and the wipers go to the down position it trips the switch in the motor that tells the computer they are in the down position. If that switch in the motor is faulty, the wipers are repositioning until the switch is tripped to the off position. THE FIX.... Replace the wiper motor.
remove wiper arms from vehicleturn wipers onthen turn wipers offshut off ignitionreplace wiper arms at the down positionthis should be the return position when ever u shut wipers off
first remove wiper arms from vehicle next with ignition on, turn wipers on then off. the wiper motor will stop at the down position. replace wiper arms onto shaft ,in the correct down position where you want them. now with ignition on, try wipers again,to check if in the stop position you want them.
A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.
because there not supposed to idiot
when u turn wipers off they stay at up position. while in up position remove wiper arms from vehicle then place wiper arms at down position and renistall on wiper motor shaft. that should fix the problem
Your wiper motor is broken. Inside the motor a wire is burned that the wipers bring back in off mode. Just replace the wiper motor.
They could be stuck, possibly from snow, ice, or other types of precipitation.
You can detailed instructions on how to reset your wipers on youtube.com/watch?v=KFBLtlnkpuI
The motor shaft and the wipers are'nt connected properly(the timing is off), just disconnect the wipers from the motor. Turn your car on and cycle the motor and it should be back at the home position. Pull your wipers back down and reconnect and all should be fine.Thats if you put in a new wipermotor. If not, maybe the wiper switch is bad.