Because you might need to ...
Depends on what you'd want to measure. Things like length and width would be the same, but finding out the mass of an object would be a little bit trickier. And if you're out in the vacuum, fluids would behave strangely due to the low pressure and the extreme temperatures.
When under peer pressure, you feel surrounded and forced by your friends to do something you don't want to or something you know isn't right.
In a way yes, If you kissed him and he didn't want to do it yes It was wrong. He was under peer pressure and didn't know what to say.
A gas or fluid will always move from a high to a low pressure if it can
You dont have to listen to the pressure. just breathe
First, this would be a tragic waste of a gemstone, if that's the one you want to crush. Diamonds are hard, they are not 'strong'. You may be able to shatter a diamond with a hammer.
Answer to "Working Under Deadlines or Pressure"You could answer "Yes, some of my best work has been done under deadlines or pressure." You might want to be prepared to give an example. Remember, though, if you don't work well under those conditions, it will show if you get the job.
you wouldn't. why would you want to?!
Putting a fluid under pressure can increase its flow rate, allowing it to be moved more efficiently through a system. It can also increase the force or power that can be generated from the fluid, for example in hydraulic systems. Additionally, pressure helps maintain the fluid's stability and prevents cavitation in pumps.
First you are going to want to have someone push one a pressure point. They are under your armpits and under your legs. Then you want to get someone to call 911. After that get gaus on it. You are going to want to reapply it when there is to much blood on it.
Answer to "Working Under Deadlines or Pressure"You could answer "Yes, some of my best work has been done under deadlines or pressure." You might want to be prepared to give an example. Remember, though, if you don't work well under those conditions, it will show if you get the job.
because you dont want them to become fluid over loaded