0
What else can I help you with?
How do you use a manometer?
A manometer is a device that is used to measure the pressure of a fluid. The U-shaped glass tube is partially filled with a liquid, usually mercury. The difference between the height of the mercury corresponds to the difference between the pressure of the fluid in the container and the atmospheric pressure.
How do you set up manometer?
To set up a manometer, first ensure that it is securely mounted in a vertical position. Fill the manometer with a fluid, typically mercury or water, making sure there are no air bubbles. Connect the manometer to the system you want to measure the pressure of, and then observe the height difference of the fluid levels in the manometer to determine the pressure.
Explain how fluids exert pressure?
The only difference between the way a fluid exerts pressure and the way a solid does is that a fluid flows into any available space, and so it exerts pressure very evenly. If you want a more detailed analysis, ultimately physical matter exerts pressure by means of the electrostatic repulsion between electrons.
What does 288 fluid ounces weigh?
The weight of 288 fluid ounces depends on the density of the liquid being measured. For water, which has a density of about 1 ounce per fluid ounce, 288 fluid ounces would weigh approximately 288 ounces, or 18 pounds. If the liquid is denser or lighter, the weight would vary accordingly.
What is a Pitometer?
It's not a unit of measurement, that's for sure. It's a piece of equipment that measures the relative velocity of fluid, such as in wastewater applications or in firefighting (when you want to know how fast and hard the water is coming through a particular piece of pipe).
Does something under high pressure want to stay at high pressure or go to something that is low pressure?
A gas or fluid will always move from a high to a low pressure if it can
Why would you want to put fluids under pressure?
Because you might need to ...
How did it feel to be under peer pressure?
When under peer pressure, you feel surrounded and forced by your friends to do something you don't want to or something you know isn't right.
Was it wrong to kiss a boy under peer pressure?
In a way yes, If you kissed him and he didn't want to do it yes It was wrong. He was under peer pressure and didn't know what to say.
Is it a good idea to just change the fluid and not the filter?
No it is not. Why would you want to pump CLEAN FLUID through a dirty FILTER.
How do you do good under pressure when you want to do good but is nervous too about doing bad and everything and you have to do good?
You dont have to listen to the pressure. just breathe
How much pressure would it take to crush a diamond?
First, this would be a tragic waste of a gemstone, if that's the one you want to crush. Diamonds are hard, they are not 'strong'. You may be able to shatter a diamond with a hammer.
Can you work well under deadlines or pressure?
Answer to "Working Under Deadlines or Pressure"You could answer "Yes, some of my best work has been done under deadlines or pressure." You might want to be prepared to give an example. Remember, though, if you don't work well under those conditions, it will show if you get the job.
Mustang red fluid leak drivers side?
Um, yeah, you may want to check the brake fluid level in your master cylinder. But, if it's not that, it could be transmission fluid, but I would expect that to be more centered under the car. Also, I suppose it could be power steering fluid, but my Mustang doesn't have power steering so I'm not familar with the placement of its reservoir.
Can you use lighter fluid to kill bees?
I'm sure lighter fluid can kill a bee but the real question is why would you want to?
Why would a patient be on fluid restrictions who is on lipids pro cal and iv fluids?
because you dont want them to become fluid over loaded
Have no pressure in your brake petle?
Most common and least expensive answer would be that somehow air has gotten into your brakelines. Check brake fluid level first. After topping it off, need to "bleed" the lines. May want a mechanic to do this if new to you.
