probably not. You have to do some major measuring of the length width and height to see if there is clearance, then check the brackets on the original bumper. if they dont match, try fabricating the old brackets onto the new bumper and you should be good to go. probably not. You have to do some major measuring of the length width and height to see if there is clearance, then check the brackets on the original bumper. if they dont match, try fabricating the old brackets onto the new bumper and you should be good to go. probably not. You have to do some major measuring of the length width and height to see if there is clearance, then check the brackets on the original bumper. if they dont match, try fabricating the old brackets onto the new bumper and you should be good to go.
I really doubt anything from Mazda will fit Camry.
yes it will
YES. It sure will.
yes it does... however, the bumper must match the car. what i mean by that is, the sedan bumper will not fit the hatch. and vice versa. the clips are the same. the outer shell is shaped a little different. eg. the back bumper has a finger groove to make it easier to open the trunk. subtle differences like that.
No, they will not fit. Mazda uses a 5x114mm pattern on their rims. Only Mazda or multi fit aftermarket rims will bolt on because no other manufacturer uses this pattern
Yes
no
Yes you can. The only difference will be that the orange marker lights in the front will not fit.
Unfortunately, a 1997 Toyota Supra engine and trans would not fit into a 1990 Mazda Miata. The Supra engine and transmission are unable to be mounted correctly within a Miata to make them fit.
yes
I dont think so. But im not positive.
it depends on the lug pattern, you just have to try and put them on and hopefully they fit, but if they dont fit dont force anything