0
What else can I help you with?
Will the bell housing from a Chevy 235 engine fit a Chevy 350 engine?
No. The 235 had a totally different bolt pattern.
What is the wire that goes from the firewall to the bell-housing on a 350 tbi Chevy?
That is a body to engine ground wire.
How many transmission to engine bolts are there on a 1998 suburban 350 vortex?
There are 6 bolts in the bell housing that hold it to the rear of the engine.
How many bolts to mount transmission to a Chevy 350?
Should be 6 bolts on the bell housing to mate it to the engine.
Can a turbo 350 Transmission be bolted on an Oldsmobile 350 Rocket engine?
only if the trans is from an olds, Buick or Pontiac engine. The bell housing bolt pattern from these engines is different from a chev block
Where is the casting number on a 70's 350 ci engine?
number is on the back of block(drivers Side) near bell housing
How do you remove a bellhousing on a Chevy 350?
to unbolt the bell housing you un bolt the six bolts that screws through the trans bell housing into the engine. they go from the back towards the front of engine. be sure to unbolt torque converter bolts too.they go through the flywheel
2001 e-350 starter solenoid location?
on top of the starte motor on the left side of engine near botom at bell housing
Where is the thermostat on a 350?
The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.
Where is the starter on a 1993 Blazer 350 engine?
The starter location on all Dodge Dakota engines is on the driver's side rear of the engine, low down and bolted to the transmission bellhousing. It will be cylindrical in shape and the positive (red/+) battery cable will run directly to it.
How do you remove starter from 350 mercruiser engine?
To remove the starter from a 350 MerCruiser engine, first disconnect the negative battery cable to ensure safety. Next, locate the starter, which is typically mounted on the lower side of the engine. Remove the wiring harness by unbolting the electrical connections, and then unscrew the mounting bolts that secure the starter to the engine. Finally, carefully pull the starter away from the engine to complete the removal process.
How much horsepower is in a mercruiser 5.7 350?
260
