answersLogoWhite

0

its not going to be the engine you have to worry about it is the clutch and flywheel check the size of the chaft and count the teeth then go to a parts store and pull a clutch for that motor or any Chevy 4x4 truck count the splines measure the size and measure the pilot shaft diameter.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is transmission located on 2000 Hyundai Elantra?

The transmission is located in close proximity to the engine, usually (in Hyundai's) transversely mounted directly under and behind the engine (behind the engine in terms of: following from the front of the vehicle towards the rear of the vehicle). If you follow the transmission fluid dipstick housing (shaft) down - that transmission fluid dipstick housing will end directly into the upper-most part of the transmission housing.


Where is the crankshaft sensor on a 1999 dodge durango 318 cid located?

It goes into the bell housing, behind the passenger side cylinder head, under the transmission dipstick tube.It goes into the bell housing, behind the passenger side cylinder head, under the transmission dipstick tube.


Infinite Starter location infinite starter placement Where is the starter on my infinite G20?

The starter should be located behind the engine on the driver side next to the Bell Housing for the transmission. The starter should be located behind the engine on the driver side next to the Bell Housing for the transmission.


Where is the speed sensor on a 1999 Kia Sephia?

The speed sensor on a 1999 Kia Sephia is located on the transmission. It is just behind the bell housing for the transmission.


Where is the park switch on a 1996 jeep?

Same as on a '97 on the right (passenger side) of the transmission by the fill port (follow the dipstick housing behind that is a part with wires going into it.). Same as on a '97 on the right (passenger side) of the transmission by the fill port (follow the dipstick housing behind that is a part with wires going into it.).


Do you have to take the trasmission apart to replace the crankshaft in a Yamaha 350 raptor?

You don't have to take the transmission apart but you will probably have to pull the engine out of the frame and take the right hand side clutch cover housing then removing the clutch then the gears behind the clutch and split the the transmission housing. When you split the housing the transmission will be separate from the crankshaft so you will have to get down to the transmission but won't have to take it apart.


Where is the crank shaft sensor in a 1994 3.5 liter chrysler?

It is on the passenger side of the transmission bell housing, behind the engine.


Where is the crankshaft position sensor on a 1995 Chrysler Concorde?

It is on the passenger side of the transmission bell housing, just behind the engine.


Where is the crank sensor on a 1996 Dodge Intrepid?

It is mounted to the passenger side of the transmission bell housing, just behind the engine.


Where is the crankshaft position sensor on Chrysler 300m 3.5l?

It is behind the engine on the passenger side, it is mounted to the transmission bell housing.


Where is the crankshaft sensor on a 2006 2.7 dodge magnum located?

Behind the engine, in the passenger side of the transmission bell housing.


Where is the speed sensor on a CLK 320?

The speed sensor on a CLK 320 is located on the transmission. It is plugged in just behind the bell housing.