answersLogoWhite

0

What else can I help you with?

Related Questions

3.1 motor has loud knocking?

if it sounds like the knocking is coming from the bottom of the engine i would bet it was the rods or rod bearings may be worn. if the knocking is on the top ,then i would have the lifters and or the rocker arms checked.


How can you tell if a rocker arm has come loose or broken on a 4g63 non turbo engine?

The main indicator of a broken or loose rocker arm in any engine is a loud knocking or rattling sound. It can also cause smoke and the engine to run roughly.


What can cause very loud knocking noise in a 2.4Liter motor?

worn, lose rocker arms


You put a jdm h22a engine in your 1992 Honda prelude and now its making a knocking noise what could it be?

There could be a problem with low old causes the pistons to rattle. There could also be a problem with the rocker arm.


What is the function of the rocker arms?

The function of a rocker arm is to control a valve in an engine. The rocker arm is a lever that rocks.


What is the function of a rocker arm?

The function of a rocker arm is to control a valve in an engine. The rocker arm is a lever that rocks.


Why is my engine Sucking air through the oil filler cap?

your problem is the rocker/engine cover is blocked the only way to fix the problem is to change the rocker/engine cover.


What will happen if a rocker arm is loose?

It will cause the engine to run rough and eventually it will damage the valve and rocker.


How do you tell which rocker tip is noisy on your el falcon?

While the engine is not running you measure the 'rocker gap' between rod and rocker with a 'feeler gauge' . Each engine has specs for this gap, and if it's too wide that's the noisy one.


Knocking noise in the engine of your 82 Mazda 323 low compression poor idle anyone any idea what could be wrong?

knocking is probably a rocker but might be a rod, sounds like its time for a master rebuild kit First check if the motor pulley. Located at the lowest part of the engine, when the v-belt runs. check if this is not loose. For poor compression, check timing on the car an a possiblilty for new spark plugs


Does a stock 350 sbc engine need different pushrods when changing from 1.5 rocker arms to 1.6 rocker arms?

no


How do you install rocker arm assembly on 1987 2.5?

There is no rocker arm assembly on a 1987 2.5 engine. Each valve has its own rocker, they are installed and adjusted one at a time.