0
What else can I help you with?
eren yeager?
i love that name plus i ship him with levi anyways eren of ereh is a titan shifter and is very nice but turned evil because of the word freedom
You locked your Gerbil in the oven and accidentilly turned it on what do you do?
accidentally eat it
If The engine can be turned by hand does that mean its not locked up?
That is correct...
You put 2001 Mazda 626 in reverse then you shift it into drive but the car still went in reverse until you turned off the engine and it would not start again The gear shift is very loose what is wrong?
the linkage between the trans and shifter is what i would check first. also, there is a switch that prevents the car from starting unless its in N or P
1986 Chrysler Fifth Ave muffler sounding noises turned into your car not going into drive or reverse and once turned off the car will not start anymore anyone know why?
Linkage from the shifter to the tranny might be broken, frayed, streched, or misadjusted, check that cable out and make sure its all set, if it is, the tranny may or may not be blown.
Automatic transmission locked in overdrive on a Volvo 240 DL?
what years is it? My 83 244gl automatic switch went bad on the shifter and was stuck with overdrive off. I pulled the switch out and unplugged it. Then I connected tapped the wires together with screwdrivers and turned the overdrive on that way. Now i just drive with it on.
Why does the belt break when ac is turned on?
AC compressor is locked up.
What does ETS off mean?
It means your traction control is turned off. Should be a button for it on the side of your shifter.
How do you turned off OD-off in car?
there is a button on the gearshift or on 1 of the shifter rods on steering column
Is the Anti theft light in a Lincoln Automobile suppose to be flashing when the car is turned off?
Yes , once it's turned off and locked
Can a reverse air conditioning lose freon when the heat is turned on?
Does a tire with a slow leak lose air when you are driving in reverse?
Are axle nuts reverse threaded?
Yes, some axle nuts are reverse threaded, meaning they must be turned counterclockwise to loosen them.
