answersLogoWhite

0

Check to be absolutely sure the wires are in the correct position between the plugs and cylinder. If they are out of order at all, the engine will seem like it wants to start real bad but it won't. If that isn't the cause, I'm out of ideas too. I had this problem on my Jeep - the order was right - but I had to move all the wires one position clockwise to make it go. You may need just to move the wires in the correct order to a different position on the distributor, each one or two positions.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you change the oil on a 1997 Ford Aspire?

how do you change the engine oil and oil filter on a 96 ford aspire


Where is the fuel filter on your 1997 aspire?

The fuel filter is probably in the fuel tank as are most fuel injected vehicles


When a filter has been applied to a datasheet clicking the Toggle Filter button will?

When a filter has been applied to a datasheet, clicking the Toggle Filter button will


Where is the oil filter located on a 1994 Ford Aspire?

left rear of engine.


How many quarts of oil does a 1995 Ford Aspire use?

With engine oil filter change , the ( 1996 Ford Aspire ) takes ( 3.6 quarts )


Where is the oil filter on a 97 aspire?

I found the oil filter bottom part of the engine in the front, it looks like a small cylinder.


Where is the oil filter on a 95 Ford Aspire?

On the side of the engine, right above the drain pan.


How many quarts of oil arein a 1996 Ford Aspire?

3.6 quarts w/filter


Where is the gas filter on a 1996 Ford Aspire?

Fuel filter is located in the engine compartment, driver's side between battery and firewall. Follow the fuel lines.


When you use filter by form to restrict record that appear you create the filter and then click what button to apply the filter?

Toggle Filter


Does the fuel filter on a 1998 Nissan Altima have a reset button for the fuel filter?

No


How do I reset the filter light on my Samsung device?

To reset the filter light on your Samsung device, locate the filter button on the control panel. Press and hold the button for 3-5 seconds until the light resets.