The flashing overdrive light on the gearshift knob typically indicates a problem with the vehicle's transmission system. This could be due to various issues, such as low Transmission Fluid, a malfunctioning sensor, or a problem with the transmission itself. It serves as a warning to the driver that the overdrive function is not engaged, which may affect fuel efficiency and performance. It's advisable to consult the vehicle's owner manual or take the car to a mechanic for diagnosis and repair.
There is a staple on the front of the gearshift just below the knob, remove it and lift the shift knob.
you have to twist it off.
Push down the gearshift, then move the gearshift to the left and forward. You must be physically pushing *down* on the knob.
unscrew it. counter clockwise.
To replace the gearshift light in a 1997 Lexus LS400, first, ensure the vehicle is in "Park" and disconnect the negative battery terminal for safety. Remove the gearshift knob by pulling it straight up, then remove the surrounding trim panel by gently prying it off. Locate the bulb socket at the base of the gearshift lever, twist it counterclockwise to remove, and replace the old bulb with a new one. Reassemble by reversing the steps and reconnecting the battery.
overdrive is turned off. This is usually controlled by a button on the shifter knob. Press it to turn of the overdrive, push it again to turn it back on.
Push in the overdrive button(located on the gear shift knob - below the shifter button).
Below the headlight knob, to the right of the power mirror knob.
That will turn off ( or turn back on ) the overdrive feature of your transmission When the overdrive is off , so the transmission only uses the first ( 3 ) gears the O/D OFF light will light up in your tachometer . Overdrive is the normally allowed position so if you shut the vehicle off , the next time it is started the overdrive feature is allowed or if you have shut the overdrive feature off just push the button again to turn the overdrive back on
I believe that is part of you security system. Eric j
The light intensity knob is found on light microscopes and allows you to change the intensity of the light on the sample. Different light intensities allow you to view different parts more clearly.
You do not have the Jeep in OverDrive and risk damaging your Jeeps transmission on the highway. To fix this hit the button on the left hand side of your gear selector knob.