5 1/4 per crutchfield.com =============================== My Diamante had factory 6.5"
To remove the rear speakers from a 2003 Mitsubishi Diamante, start by carefully prying off the speaker grilles using a flathead screwdriver or a trim removal tool. Next, unscrew the mounting screws holding the speakers in place. Once the screws are removed, gently pull the speaker out, disconnect the wiring harness, and the speaker will be free. Reverse the process to install new speakers if needed.
3 bolts 2 wires
No, there is not.
about $700 to $800...with a new water pump
Remove the covers from your 2003 Chevrolet Avalanche speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
the oil filter is next to the oil pan underneath the car( passenger-side)
what size are the front and rear speakers for a 2003 pajero
To remove the factory alarm from a 2003 Mitsubishi Diamante, you typically need to disconnect the alarm system's main control unit, which is usually located under the dashboard or near the fuse box. You may also need to disconnect the battery to avoid triggering the alarm while working on it. Additionally, consult the vehicle's service manual for specific wiring diagrams and procedures, as the process can vary based on the alarm's configuration. If you're unsure, it's advisable to seek assistance from a professional mechanic.
pull it out
To change the distributor cap on a 2003 Mitsubishi Diamante, first ensure the engine is off and cool. Disconnect the negative battery cable, then remove the screws or clips securing the distributor cap. Carefully lift off the old cap, noting the position of the ignition wires, and transfer them to the new cap. Finally, secure the new cap in place, reconnect the battery, and start the engine to check for proper operation.
To replace the water pump on a 2003 Mitsubishi Diamante, first, disconnect the negative battery terminal and drain the coolant. Remove the serpentine belt and any components obstructing access to the water pump, such as the timing cover. Once accessible, unbolt the old water pump, clean the gasket surface, and install the new pump with a new gasket. Finally, reassemble everything, refill the coolant, and reconnect the battery.