unclip the old one, unscrew it. then screw in the new one and clip the new one on
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
where is a knock sensor located on a 96 Pontiac Bonneville
where is a map sensor loction for 1994 ponatic bonneville?
To replace the ambient temperature sensor on a 2000 Pontiac Bonneville, first locate the sensor, which is typically found near the front of the vehicle, often near the grille or bumper. Disconnect the wiring harness from the sensor and remove it from its mounting bracket. Install the new sensor by securing it in place and reconnecting the wiring harness. Finally, test the sensor to ensure it's functioning correctly.
You got to have a star bit with a hole in the middle the mad is on top of the air duct
Typically the O2 sensor is located at the back of the engine, follow the exhaust manifold and it should be attached somewhere near it
There are two oxygen sensors, there is one located in the exhaust system before the catalytic converter and one after the catalytic converter.
Try looking at the back of the engine on the maifold just before it connects to the exhaust pipe.
The cam shaft sensor is located behind the water pump pulley. One bolt that holds it in place.
Cam Sensor Circuit
Rear of engine follow exhaust manifold at rear of motor(closest to firewall) you will see oxygen sensor there.Simple to remove(1 only on this motor)
bad idle and chec engine light comes on. this can be checked with and obd 1 code reader