answersLogoWhite

0

Your engine is misfiring, meaning one or more cylinders are loosing spark, fuel, or there is a mechanical problem. A flashing MIL light will always indicate a misfire. A scan tool check may reveal freeze frame data to help correct the issue.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why does a check engine light blink on a 1998 Mazda 626?

If the check engine light is blinking , an engine cylinder misfire has been detected


How do you check engine codes on a 1993 jeep?

With a scan tool, or try turning key on, off, on, off, on and counting the blinks of the check engine light. blink, blink, blink, pause, blink would be 31.


Why does your check engine light blink?

A flashing check engine light is usually an indication of a misfire.


How do you get check engine codes without an obd?

On some if you turn key on, off, on, off, on. The check engine light may start to flash the code. blink, blink, bink, pause blink would be 31.


Why check engine lamp blink?

A flashing engine light is usually a misfire.


Why would check engine light blink on my Oldsmobile cutlass?

Probably because you need to check the engine.


Mazda MPV 1992 How do you read diagnostic codes lamp Check engine is ON?

how to reset check engine light on 1992 Mazda mpv


Why does the check engine light blink on your 1998 mercury mountaineer?

An engine misfire has been detected


What causes check engine light to blink on and off?

Check to see if your gas cap is tight.


Check engine light Mazda Tribute?

The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.


What causes the check engine light to blink on and off and then stop blink and turn off?

It is indicating that there is a fault with the engine of the car. You need to take it to a garage for repair/service.


How do i find out what the check engine light is on for on a BMW?

first you nee to check and see if your car is referred to as OBDI or OBDII if its ODBI then you start with the car off.. turn the key to run but do not start the engine.. at this point you have less that 5 seconds to push the gas pedall all the way to the floor and press the overdrive button five times... then the check engine light will stay on.. and then blink... next its going to blink out the code for you for ex. blink-pause-blink blink-pause blink blink blink-pause blink n that would mean the problem code is 1231 just Google BMW problem codes and use that dcode to find out what the issue is..