Depends on the vehicle. There is one on the passenger side which is the front of the engine, but could be considered the upper right. There may also be one at the front of the car that connects to the radiator support that would be the front one.
To change the upper right engine mount on a 2004 Toyota Sienna, first, secure the vehicle on a level surface and raise the front with jack stands. Remove the engine cover and any components obstructing access to the mount. Support the engine with a jack, then unbolt the old mount from the engine and chassis, and replace it with the new mount. Finally, reassemble any removed components and lower the vehicle.
4 - Right lower bottom rear and Right upper front, Transmission mount and Torque mount
Right off the water pump, upper hose, right side of engine (from the front)
Upper front right portion of the engine.
Upper front right part of the engine.
right front top of engine housing upper hose goes to it
On the front of the engine.As you are looking at the front of the engine it will be on the upper left hand side, attached to the block and head.
Usually in the housing at the engine end of the upper radiator hose right in the front of the engine just follow the large radiator hose to the front of the engine
Looking at the engine from the front of the car, the EGR valve is directly behind the valve cover (right side). It has a wiring harness connected to it with multiple wires. It sits straight down on the engine and is attached with two bolts. ( Note: the front of the valve cover is next to the upper engine mount)
To remove the upper right motor mount on a 2002 Cavalier with a 2.2L Ecotec engine, first ensure the vehicle is securely lifted and supported. Remove the bolt securing the mount to the engine and the bolts that attach it to the frame. You may need to remove any components obstructing access, such as the air intake or battery. Once all bolts are removed, carefully lift the mount out of its position.
lift and support vehicle on stands, support engine with a jack with a 2x4, so you dont damage the oil pan. lift engine remove upper bolt for front motor mount then removed the three bottom bolts, remove and seperate the mounts. replace with new. replace all removed parts
You need to jack it up enough to take the weight of of the mount.