If the light should be coloured e.g. red or amber, that would be an offence in the UK.
Open the hood under there is a black cover over the head lights pull the center out o the pins there should be 2 then lift cover there should be two plastic pull handles that you need to lift up that lets that light assembly pull out then you can pull the light out from the assembly
eassy pull the fuse box cover off turn it over located the tail light fuse pull it out replace with same amp fuse
To replace the dome light on a Grand Am, unscrew the light cover. Pull it down gently. Disconnect the light. Connect the new light, replace the light cover, and replace the screws.
yes you can....first locate the grey or white screws ..... normally behind the pull out sections in the rear cargo area ....and then unscrew them (okay obvious) and then gently pull off the lens cover...... dont pull off to hard as this might damage the bulb holder underneath.... hope this helps
bulbs pull out from the back of tail light
to be under cover
two screws on the side of the bed where the tailgate closes over have to be taken out. then you pull the whole light assembly out there are two pins in the light to hold it in they sould pull right out they will hold the light back at first and make it hard to pull but pull strait out so you dont break the pins.
You unclip the holders by pushing in at each end of the the cover and gently pull up. Dont force it
Pull the plug out, remove the rubber cover, pinch the 2 metal pieces and twist the bull slightly to one of the sides you will be able to feel it go and pull it out. then do it in reverse to get the new light in. DONT TOUCH THE GLASS!
pull down the tailgate and the screws to take off the tail light cover. pull that off and it is the bottom bulb
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
Easy... Remove the courtesy light and you will see the base of aerial. It has a metal cover over the mounting nut, so using a mole-wrench or similar grab hold of the cover and simply pull it straight down. Undo the nut that's underneath the cover, pull off the aerial cable and then you can then remove the aerial base.