+ goes to starter solenoid, - goes to distributor side post. center plug wire goes to center plug on distributor.
look at the coil, it is marked - or +
how do you put spark wires in the right place on the coil pack on a 1995 Chevy cavalier2.2 frank
To much resistance in the spark plug wires, replace the spark plug wires.
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
here is a diagram
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
under the coil packs and the coil packs are connected to the spark plug wires
no distributor or spark plug wires its a coil pack on the top of the engine.
A 1992 Chevy Camaro RS typically uses ignition wires to connect the spark plugs to the ignition coil. The ignition system consists of coils and wires, where the coils generate the spark needed for combustion, and the wires deliver that spark to each cylinder. If you're referring to the suspension system, the Camaro RS has coil springs in its setup.
THE COIL ON A 1977 CHEVY TRUCKIS IN THE DISTRIBUTOR CAP. TAKE THE PLUG WIRES AND HOLD DOWN RING OFFOF THE CAP TO EXPOSE THE COIL. WEDGEMAN
disconnect wires and label them,each coil has its own screws holding it to plate,take out scews,pull coil straight up do not bend the coil tangs at mounting of coil. Do this for each coil! HOPE THIS HELPS!
replacing coil does not work for long