Simply "clamp-on" the clamp of the amp meter to any electrical conductor supplying the equipment that you wish to check while it is in operation. It is better to use your clamp-on with each individual conductor one at a time.
Yes, when using a step down transformer the amperage is affected.
no
To calculate the amperage, you need to know the resistance in the circuit. Amperage is calculated using Ohm's Law: Amperage (A) = Voltage (V) / Resistance (R). Without knowing the resistance, we cannot determine the amperage.
they would get soil reading from the short one, obviously, and body readings from the long one.
An ammeter measures amperage not voltage.
You can calculate amperage (A) using the formula A = W / V, where W is the power in watts and V is the voltage. Simply divide the power in watts by the voltage to find the amperage.
Wire size is based on the amperage drawn. To find the amperage, the voltage must be stated. Use this formula to find the amperage. I = W/E. Amps = Watts/ Volts. Once you have the amperage, restate your question using the new found amperage or state the voltage that supplies the lights.
The amperage input of a transformer on a 208V three-phase system can be calculated using the formula: Amperage (A) = Power (Watts) / (Voltage (V) x √3). To determine the amperage, you need to know the power rating of the transformer in watts (or kilowatts). Once you have that, you can plug the values into the formula to find the input amperage.
The easiest method today is by using a clamp meter. It "clamps" around a single conductor and measures the magnetic field (you can't get a reading by clamping around a regular appliance cord, as both conductors will cancel each other out).
With kitchen tongs. A mild tingling indicates low voltage/low amperage. Muscular spasms indicate high voltage/low amperage. Unconsciousness sans death indicates low voltage/moderate amperage. Death indicates high amperage. Good luck.
The strength of an electric current is measured in amperes (A) using an ammeter. An ammeter is a device that is connected in series in a circuit to measure the flow of current. The higher the current flowing through a circuit, the higher the amperage reading on the ammeter.
I don’t know