0
To convert 1400 RPM to 2800 RPM using a pulley system, you would need to use a pulley ratio that doubles the speed. This can be achieved by using a smaller drive pulley on the motor (connected to the 1400 RPM source) and a larger driven pulley on the output shaft. The size ratio of the drive pulley to the driven pulley should be 1:2, meaning for every rotation of the drive pulley, the driven pulley makes two rotations, effectively doubling the RPM to 2800.
What else can I help you with?
Can a 2800 rpm motor replace a 1400 rpm motor for air compressor?
No
Can 2800 rpm motor replace 1400 rpm motor for centrifugal water pump?
No. The water pump is designed for a specific RPM. It will not operate correctly, and will probably be damaged, if you attempt to operate it at twice the design RPM.
How to calculate belt conveyor speed with motor RPM and ger rastioc?
we know motor rpm, gearbox ratio, gear spoket no of teeth, conveyor pully spoket no of teeth and conveyor pully O.D. Exm- we have a motor of 1500 rpm, gearbox ratio 30:1, gear spoket no of teeth 24, conveyor spoket no of teeth 48, and conveyor pully (head pully) od is 200 mm, Solu- motor speed- 1500 rpm gear output - 1500/30 = 50 rpm conveyor pully rpm - 24*50/48 = 25 rpm conveyor pully cercumfrance - 200*3.14 = 628 mm or 0.628 meter conveyor speed - 25*0.628 = 15.700 meter per menuts
How much horsepower does 5.0 vortec have?
215@2800. Rpm
When should you shift in a 1984 corvette with RPM?
Red-line is at 4200 RPM and peak torque of 290 pounds-feet is at 2800 RPM.
What is the rpm for a 25HP submersible pump?
1400
How much horse power does a 5.0 vortec have?
220 horse @2800 rpm
A drive pully is spinning 600 rpm and has a diameter of 40 millimeters the driven pully has a diameter of 120 millimeters what speed would the driven pully be?
You would use a 5 inch sheave.
Dodge cummins what is the RPM optimal?
1400 - 1450 RPMs.
86 nissen 4 wheel drive extended cab pick up how can you get your pick up to rev higher then 2800 rpm's at about 2800 rpm's the pick up sputters once you press on the gas petal at 2800 rpm's?
Check the possibility that the timing chain/belt has slipped. Verify the ignition timing. Also make sure that the distributor cap is not damaged, cracked or that moisture is on the inside.
How Shift gear RPM 13 speed eaton fuller transmission?
Keep rpm between 1400 to 1600
How much horsepower is in a stock 2004 3.8 v6 mustang?
There is 193 HP at 5500 rpm and 225 lb/ft of torque at 2800 rpm.
