0
What else can I help you with?
Why would an input shaft leak on a transmission?
Because of a bad input shaft seal. Replacing this requires that the transmission be removed from the vehicle.
What rattles in a 1997 wrangler when it is in third gear?
Your input shaft bearing is going bad, it will get worse if not replaced
What drives the gearbox input shaft?
the input shaft has splines on it which connect to the clutch friction plate.
Why does your Wrangler rattle in gear?
Input shaft bearing is probably bad, especially if it is noisy in every gear but 4th
What is the position of the input shaft compared to the output shaft?
Inline
Can you make the input shaft turn by turning the output shaft?
yes
What is the name of the gearbox shaft which is 'splined' to accept the clutch plate?
front transmition shaft Input Shaft
What are Symptoms of an input shaft leak?
If you mean dripping out of the of the tranny where the shaft slips in then the leaking is it
Can you turn a input shaft by turning an output shaft?
Manual transmission that is in gear-YES
How can you tell if the CV joint on a 2002 Jeep Grand Cherokee is going bad?
I think you mean axle shaft joint. A crunching noise, especially when turning corners suggests bad axle shaft joints.
How do you know that the crank shaft is bad?
How do I know if a shaft is bad on a Ford
How do you tell if the slave cylinder is bad?
The shaft seal will leak or not work when the system has been properly bled.
