To change the brake light on a Kia Sedona, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place, then gently pull it out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, and reassemble the tail light assembly.
The spot to connect the remote starter parking light to the brake wiring in a 2002 Kia Sedona is just above the brake pedal.
possibly have a brake light out
You need to have the engine and brake systems checked for codes. See related questions below.
how to change a water pump Kia Sedona 2002
it happened to my 2003 kia sedona it was the alternator it was not chargeing need to be replaced (very long time to replace like 6.5 hours) had shop do it
how to change alternator in 2006 kia sedona
how to remove airbag light on kia sedona
how to change airbags the kia sedona 2004
Pull the cover towards you (away from the glass). Then just twist the bulb sockets counter-clockwise about 45 degrees and pull down.
Remove the tail light assembly cover in the cargo compartment. Take hold of the brake light connector. Push the connector in and turn at the same time. Do the same with the brake lightbulb. Reverse the process to install the new brake lightbulb.
The battery light stays on when the alternator is over or under charging. The red brake light stays on when the parking brake is set or the fluid is low. The abs light stays on when the abs computer detects a malfunction and sets a code.
Any tips on changing the power steering pump on my kia sedona