Do you want to replace all the wiring or just part? There's a company known as PAINLESS WIRING DO a Google search on them, they are a leader in the wiring of autos, they can even make up a custom wiring harness if you need it. If you just need replacement wiring, maybe check the local salvage yards but that may be a tough find.
go to earlycj5.com and search, lots of jeepster folks and some tech articles which should get you there.
The Willys-Overland Jeepster was produced between the years 1948 to 1950. This Jeep was modelled around a military style design; mainly marketed to foresters and farmers.
Wagonners, pickups, and the Jeepster had disc brakes in 1972. The CJ did not get disc brakes until 1977.
Follow the wiring harness from your blinker. Disconnect the factory harness from the relay. Replace with the new relay.
1993 Jeep Cherokee Ignition Wiring ...
The wiring diagram for a wiper motor of this car can be found in its maintenance manual. The manual can be purchased at an auto part store.
Most Jeep dealerships will give you a free 1994 Jeep Grand Cherokee wiring diagram. You can also find the wiring diagram in most Jeep service manuals.
Either replace the burnt wire or run new to the blower motor with a toggle switch.
Remove the fuel pump fuse. Disconnect the wiring then the fuel lines. unbolt the pump and replace. Reverse the procedure to finish installation.
Not without major modifications. The transmission, wiring, computers, etc are all different.
I Remember Jeep was created in 1970.
You have a short in the wiring, find the short and replace the wire. Tip: The vehicle is 60 years old, I would replace all the wiring, they may have complete wire harnesses for that vehicle. (J C Whitney's maybe).