To change the master cylinder on a 2005 Ford Explorer Sport Trac, first, ensure the vehicle is on a flat surface and the engine is off. Disconnect the negative battery terminal, then remove the brake fluid from the master cylinder reservoir to prevent spills. Unbolt the master cylinder from the brake booster, detach the brake lines (using a line wrench), and remove the old master cylinder. Install the new master cylinder by reversing these steps, ensuring to bleed the brake system afterward to remove any air.
The clutch master cylinder is in your engine compartment , the hydraulic clutch slave cylinder is inside your manual transmission bell housing
How do I put on a 2001 ford explorer cylinder? I am in the process of changing my front brakes and the cylinders will not push back in?
firewall 3 - 6 2 - 5 1 - 4 front of Ford Explorer
No
vacuum leak at the master cylinder or vacuum line to the master cylinder
The # 3 engine cylinder has a misfire On a 2001 Ford Explorer Sport Trac the engine cylinder locations are numbered firewall 3 - 6 2 - 5 1 - 4 front of vehicle
Your # 1 engine cylinder is MISFIRING The engine cylinder locations on your Ford Explorer Sport Trac are numbered : firewall 3 - 6 2 - 5 1 - 4 front of vehicle
Check your brake fluid level in the brake master cylinder in your engine compartment when it is low your brake warning light will come on
the code p0304 is cylinder 4 misfire detected
According to the ( 2001 ) Ford Explorer Sport Trac Owner Guide : The 4.0 litre SOHC , V6 engine takes : With engine oil filter change : ( 5.0 U.S. quarts of 5W-30 engine oil )
The fuse for your 2002 Ford Explorer Sport is similar to that of the 2001 Ford Explorer Sport.
It goes into the master cylinder on the far driver side of the firewall.