I have never owned one of these, but most radiators have a petcock on the bottom for draining. That would be the fist place I would check.
NO it's not a turbo, it has a 222horsepower DOHC motor.
In the 1992 Dodge Stealth DOHC non-turbo model, the coolant temperature sensor is typically located near the thermostat housing on the engine. Specifically, it is often found on the driver's side of the engine block, near the intake manifold. Accessing it may require removing some components for easier reach, depending on your specific setup. Always consult the vehicle's service manual for precise details and guidance.
To replace the water pump on a 1994 Dodge Stealth RT V6 24V DOHC, first disconnect the battery and drain the coolant. Remove the serpentine belt and any components obstructing access to the water pump, such as the timing belt cover. After removing the timing belt, unbolt the water pump and replace it with the new one, ensuring a proper gasket seal. Reassemble in reverse order, refill the coolant, and check for leaks.
No, a transmission from a 1991 DOHC Dodge Stealth will not work in a 1992 SOHC Dodge Stealth. The two models have different engine configurations and possibly different transmission designs, which can lead to incompatibility in mounting points, wiring, and gear ratios. It's essential to match the transmission with the specific engine type to ensure proper fit and function. Always consult with a mechanic or parts specialist for confirmation.
I currently own a 91 soch, but this is my second Stealth. My first was a 92 es dohc,,yes they have ECS. I had to replace it in mine.
yes it is possible to do it i just got done with one i put the dohc is a 91 dodge stealth mounts are the same u have to change the the wiring harness both of them under the hood and the computers the ac lines power steering resivour and lines it is a little of a pain to do but it is possible u need any more answers about it email me at beaner_in_ky@yahoo.com
To replace the water pump on a 1991 Dodge Stealth ES 24V V6 DOHC, first disconnect the battery and drain the coolant. Remove the serpentine belt, then detach the timing belt cover to access the water pump. Take off the timing belt, unbolt the old water pump, and clean the mounting surface before installing the new pump. Finally, reassemble by reversing the steps, ensuring all bolts are torqued to specifications, and refill the cooling system with coolant.
i had mine buried at 160 and still climbing at 5200 rpm
under the icm which is under the coil packs u should have a couple elec connectors screwed in the side of motor the one you want is the second one I think if not the third.....JAC
bad coil pack... replace coil pack
The oil dipstick length for a 1991 Dodge Stealth DOHC engine is approximately 32.5 inches (82.5 cm). However, it's always best to consult the vehicle's service manual or a dealership for the most accurate specifications. If you're replacing the dipstick, ensure it matches the original for proper measurement and function.
It could be water/coolant leaking from the water pump. It will only leak under pressure and can easily cause the engine to overheat. The water pump should be replaced during the 60K service.