i had mine buried at 160 and still climbing at 5200 rpm
I currently own a 91 soch, but this is my second Stealth. My first was a 92 es dohc,,yes they have ECS. I had to replace it in mine.
NO it's not a turbo, it has a 222horsepower DOHC motor.
its under the passenger side rear tire
bad coil pack... replace coil pack
the avenger
yes as long as the engines of both cars were both the same engine. IE: both were SOHC. Or both were DOHC.
yes it is possible to do it i just got done with one i put the dohc is a 91 dodge stealth mounts are the same u have to change the the wiring harness both of them under the hood and the computers the ac lines power steering resivour and lines it is a little of a pain to do but it is possible u need any more answers about it email me at beaner_in_ky@yahoo.com
In a 1993 Dodge Stealth with a DOHC engine, the Engine Control Module (ECM) is typically located under the dashboard on the driver's side. It is mounted to the firewall, near the center of the vehicle. To access it, you may need to remove some panels or the lower dash trim. Always ensure the vehicle is off and the battery is disconnected before attempting to access or work on the ECM.
I have never owned one of these, but most radiators have a petcock on the bottom for draining. That would be the fist place I would check.
on the 4G63 it runs off the cam-shaft. otherwise, it is behind the crankshaft pulley, an inductive bell and strobe setup. The previious answer is true, but the 92 Dodge Stealth came with 3 engine options. The Base Model came with a SOHC 6G72, The ES and RT with a DOHC 6G72 and the RT/TT with a Twin Turbo DOHC 6G72. In answer to te question in 92 the crank sensor is run off the camshaft similar to the 4G63. It is located on the intake camshaft, of the rear head on the transmission or rear of the block
3.0 sohc looks small in compartment and transmission sets on left side. 3.0 dohc is much larger and has 2 belts running the cams
just need a good tune up and again ajust the throttle body rpm screw.