First, locate the fuse box. Then, once inside the fuse box, locate the 120 amp fuse. Remove it by pulling it straight out. Lastly, place the new one in place of the old one.
driver side foot area in fuse block. #11
help
this is the 30 amp egi fuse in your fuse box in your engine comp.
To change the main 120 amp fuse in a 2000 Mazda Millenia, first ensure the vehicle is off and disconnect the negative battery terminal for safety. Locate the fuse box, typically found near the battery or under the dashboard. Remove the old fuse using a fuse puller or pliers, and replace it with a new 120 amp fuse, ensuring it fits securely. Finally, reconnect the negative battery terminal and check that all electrical systems are functioning properly.
do you have 2000 mazda 626 dash board?
You can check underneath the dashboard to find the fuse. Use the car's manual to guide you accordingly on where the fuse is.
this is the 30 amp egi fuse in your fuse box in your engine comp.
How do you change the liscence plate light fuse
on the driver side to the left there is a little box there and its a 10 a fuse should be the 2ed one from the top
You can find the fuse box diagram on page 6-10 of your owners manual.
In a 2000 Mazda Protegé, the ECU (Engine Control Unit) fuse is typically located in the fuse box under the dashboard on the driver's side. To access it, you'll need to remove the cover of the fuse box. The specific fuse for the ECU is usually labeled in the diagram on the cover or in the owner's manual, often designated as the "ECU" or "Engine" fuse. Be sure to check the diagram for the correct fuse location and rating.
the fuse is located inside the passenger compartment in the fuse box close to the hood release latch-20 amps