answersLogoWhite

0

Remove and contain the refrigerant; if you suspect the compressor motor has a burnd-out; treat the refrigerant as contaminated. Disconnect the lines from the compressor, including electrical, replace the filter, and compressor, purge the system, check for leaks, vent the nitrogen, do a pull down below 500 microns, replace refrigerant, and oil. do a run up check pressures, and temp.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the compressor located in an AC unit?

The compressor in an AC unit is typically located outside the building, near the condenser unit.


Where is the compressor located on an AC unit?

The compressor in an AC unit is typically located outside the building, near the condenser unit.


Is it a must to change the orifice tube when replacing ac compressor?

If I change the AC compressor in a car, do I have to change the orifice?


1997 buick AC Can you change the clutch with out taking the unit off the car and compromising the AC compressor?

yes but a very special tool is needed


Why does your ac unit not cycle off and on?

Bad compressor


Can you use 3 split ac unit on one compressor unit?

Up to 2 forced air units to one compressor unit.


Do you have to discharge the ac when replacing AC clutch?

no, unless u have to remove the compressor unit. The clutch can be replaced with out removing the compressor if you have room to do it.


How do you replace an ac compressor on 2000 dodge caravan?

my ac compressor is bad and i want to change it myself how can i do this


If you change your car refrigerant R12 to R134A do you have to change the AC compressor?

No you don't have to change the A/C Compressor.


What is the role of the motor in an AC unit?

The motor in an AC unit is responsible for powering the fan and compressor, which are essential components for circulating and cooling the air in the unit.


What causes compressor to lock out ina home ac?

what causes compressor lockout in voager rooftop unit.


How do you change a ac compressor on a 2000 Chrysler cirrus?

To change the AC compressor on a 2000 Chrysler Cirrus, first disconnect the battery and recover the refrigerant from the AC system. Next, remove the serpentine belt and disconnect the compressor's electrical connector and refrigerant lines. After unbolting the compressor from its mounting bracket, replace it with the new unit, ensuring all seals are replaced. Finally, reconnect the refrigerant lines, electrical connector, and serpentine belt, then recharge the AC system with refrigerant.