What a pain in the butt. After opening up the access panel in the back, I couldn't get my hand in the hole far enough to turn out the bulb socket. After 1/2 hour I finally found a small pair of plyers, a mirror and a flashlight. I was able to get the plyers in the acess panel and make the 1/4 turn counterclokwise in order to extract the socket. Then I just pulled the bulb out of the socket and replaced.
Good luck everyone.
Bish80
To change the headlamp on a Scion xA, first, open the hood and locate the back of the headlamp assembly. Disconnect the wiring harness and remove the retaining clip or screws to take out the old bulb. Replace it with a new bulb, ensuring not to touch the glass with your fingers, and reassemble everything. For the blinker, access the bulb by turning the socket counterclockwise from the housing, remove the old bulb, insert the new one, and secure it back in place.
remove tail light, remove burnt bulb, replace burnt bulb, test if it works, then put tail light back on....
To change the rear blinker on a 2006 Ford Freestyle, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place, then gently pull it out. Twist the socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the bulb is securely in place before testing the blinker.
front or rear?
After you put that down
How do you change a front blinker bulb for a BMW X5 2001?
To change the front blinker bulb on your 1986 Chevy Celebrity simply reach up behind the bumper and unplug the socket from the fixture. Replace the bulb in the socket and plug the socket back into the fixture.
To change the left blinker bulb on a 2003 KIA Spectra, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then carefully pull it out. Locate the bulb socket for the left blinker, twist it counterclockwise to remove, and then replace the old bulb with a new one. Reinstall the socket, reattach the headlight assembly, and test the blinker to ensure it works.
The bulb.
change the bulb
Simply look behind the light (from inside the trunk or under the hood), and you access the bulb from their. turn the backing of the bulb to release it and simply change the bulb. A simple fix.
Which bulb are you speaking of? The in-dash indicater or your outside turn signal?