Support the car on jack stands.you should spray all bolts with PB Blast it will help losen bolts easer.Then you use a spring compressor tool.As you tighten the bolts it collapses the spring.You can also use a torch to weaken the springs.Be very careful the spring is under tension it can jump out and injure you.Losen and remove bolts.Replace new springs.You can use a car jack to put pressure on the springs during instillation you take your time its easy be careful not to hit brake lines or outher delicates. Good Luck
Yes, this should be a perfect fit.
Any rear seat out of 1968-72 Nova's, no the camaro rear seat will not fit they are different sizes. Just throw that in there because most people think because the two cars share major components that these also are interchangeable when they are not.
Replace the stock tail panel with a 68 thru 72 panel.Next swap gas tanks the 73 neck faces up above the bumper not downward like the 68 thru 72.The final step install a 68/72 rear bumper to finish it off.
Available engine packages, and Chevy did away with the 12 bolt rear end in 71.
Yes
Yes it will bolt right on
On my 72 nova the wire going to the blower looks to be purple.
you have to pull the axle completely out of the rearend and the bearing is on the axle and you have to press it off the axle to get it off and press the new one on.
I know that the 74 nova has what was called minor impact bumpers, and these were new in 74, the 73 didnt have the same set up, although the bumpers were the same on the outside, the 74 bumpers are alot heavier, front and rear. The 72 nova has the gas filler in the bumper, as the 73-4 has the gas filler in the taillight panel, you could still use the 72 bumper on the 74, but you couldn't use the 74 bumper on a 72.Not that you would want to. I have a 74 custom, but i never saw one with say 68-72 bumpers on it, but im pretty sure it could be done fairly easily.
Yes, they are.
Perhaps with some modification
It should fit as there the same body .