Unplug it from the accumulator and run a jumper wire between the two holes. If the compressor clutch remains engaged while the jumper wire is in place, the switch is functioning properly.
Changing the brake light relay switch on your 1999 Chevy Cavalier is quite easy. The brake light switch simply plugs in and out.
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
Low on freon, faulty pressure switch, faulty clutch. Jumper the low pressure switch with a paperclip (can running, AC on), if the clutch cycles, it's either low on freon, or the low pressure switch is bad.
Replace the switch.
Check all of the following............. 1. Pressure switch. 2. Pressure switch pigtail. 3. A/C heater controller.........
Audi A4 1999 1.9TDi Oil pressure light on continously. Engine sounds fine. How do I remove electrical connector to remove switch and check pressure with a gauge?
where is the oil pressure switch on a 1999 chevy surburban
Remove the fuel rail
To unplug the oil pressure switch for a 1999 Chrysler Sebring 2.5, simply remove the connector from the back of the switch. With the switch unplugged, the computer will think the engine has low oil pressure.
If you're positive it's not the bulbs (you know this because you checked them with a meter or tested the outlet with a test light maybe) or switch, check it out for a bad ground.
The 1999 Chevy Cavalier does not come with a factory-installed kill switch. However, some owners may have added aftermarket kill switches for security purposes. If you're concerned about theft or want to install one, consider consulting a professional for proper installation.
If auto Check the rear passenger side of engine