answersLogoWhite

0

remove hot or positive terminal.turn key forward as if to start let sit for30 seconds turn back key. replace. terminal codes will be lost but current problem codes will return service as needed. good luck! from mr. Jason

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Can you replace a 1990 Mazda b2600i engine with a 1986 Mazda b2200 engine?

yes you can its a straight swap you don't even have to change engine mounts


Does the 1990 Mazda b2600I pickup truck have a non-locking rear wheel?

The SE-5 package has a limited slip differential but it doesn't fully lock.


Where is the fuel pump relay on a 1990 Mazda b2600i 4x4?

The fuel pump relay on a 1990 Mazda B2600i 4x4 is typically located in the engine compartment, near the battery or in the relay box. You may need to consult the vehicle's service manual for the exact location, as it can vary slightly depending on the specific configuration. It's usually labeled, making it easier to identify among other relays.


Location of crank sensor on 1990 Mazda b2600i?

The B2600i does not use a crank angle sensor, it uses a hall effect sensor located inside the distributor to time the engine based off of the camshaft. See the attached link for additional information. K6 Mazdatruckin.com


B2600 is there an automatic 4x4 model?

I found a listing for a 1988 Mazda B2600 ( 2.6 L 4 cylinder engine / 3 speed automatic transmission / 4X4 ) and listings for 1990 through 1993 Mazda B2600I ( 2.6 L 4 cylinder engine / 4 speed automatic transmission / 4X4 )


How do i clear codes for 1990 Volvo?

Try disconnecting the + battery cable for 5 minutes.


What causes a 1990 Mazda B2600i to start and idle fine but stall when you touch the gas pedal?

It sounds like low fuel pressure could be a real possibility. It could be a partially blocked filter, weak fuel pump or a faulty fuel pressure regulator.


Where is the freeze plugs on a 1992 B2600i Mazda?

I just popped mine out on a 1990, I hope. It was only about 30 Fahrenheit, I think. Anyway, the fluid is pouring out of a round hole under the drivers side exhaust manifold. All I had to remove to see it was the cowling. Wish me luck and the same to you.


Power brake 1990 Mazda 929 fails?

929 1990 Mazda power brakes fails


Transmission in a 1990 Mazda rx7 convertible automatic?

Yes, there is a transmission in a 1990 Mazda RX7 convertible.


How can one replace a cornering light on 1990 Mazda 626 dx?

How can one replace a cornering light on 1990 Mazda dx


Where is the egr valve located on a 1990 Mazda mpv 6 cylinder?

There is no egr valve on a 1990 Mazda MPV 6 cylinder