0
To clear codes on a 2002 Buick Rendezvous, you'll need an OBD-II scanner. Connect the scanner to the vehicle's diagnostic port, typically located under the dashboard near the driver's side. After reading the codes, select the option to clear or erase the codes. Once completed, disconnect the scanner, and the check engine light should turn off if the issues have been resolved.
What else can I help you with?
When was Love Rendezvous created?
Love Rendezvous was created on 1995-10-02.
When was Dangerous Rendezvous created?
Dangerous Rendezvous was created on 1968-02-09.
How many cooling fan relays does an 02 Buick rendezvous have?
3 relays
How do you change the key fob battery for a 02 buick rendezvous?
The key fob battery in an 02 Buick Rendezvous is changed by prying the case open using a coin or screwdriver. The battery can then be pulled out and a new battery installed.
Does auto zone clear codes?
No.....its against the law to clear codes.
Why wont codes clear when trying to clear them?
The codes are telling you there is a problem. If the problem is not fixed the codes will come back.
Which is the fuse to clear dtc codes on a 2005 Chrysler sebring convertible?
Pulling a fuse will not clear codes on this vehicle. A scan tool is required to clear codes.
How do you reset computer in a 2005 buick rendezvous?
To reset the computer in a 2005 Buick Rendezvous, you can disconnect the negative battery cable for about 10-15 minutes. This will clear any stored codes and reset the system. After reconnecting the battery, start the vehicle and allow it to idle for a few minutes to enable the computer to recalibrate. Make sure to check for any warning lights after the reset.
How do you replace motor mounts on 02 Buick Rendezvous?
replace 2002 buick rendevous motor mount
How do you reset the service engine soon light in a 2004 Buick rendezvous?
To reset the "Service Engine Soon" light in a 2004 Buick Rendezvous, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the vehicle's computer system and turn off the light. Alternatively, you can use an OBD-II scanner to read and clear the trouble codes. However, it's important to address any underlying issues that triggered the light before resetting it.
Can you have some 02 surprise codes?
No.
Where is the camshaft sensor 0n an 02 Rendezvous?
Directly beneath the power steering pump on the passenger side of the engine.
