answersLogoWhite

0

Remove the lock, take the cylinder out then replace with the correct bottom pins so they suit the key. Common cause of this fault is when someone does not cut a key properly or is an older key that has worn down over time

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

When I put my key into the fuel door lock on my 1998 Tacoma the lock will turn but it won't unlock it?

I also have a 98 tacoma and my key wont turn the door lock I took it to the dealership an they ordered me a new cylinder and they are going to rekey it for me thats what im doing. Your cylinder or plastic on the back of the cylinder could of broke


1989 Audi door wont unlock with key?

Will the key turn in the cylinder? i f yes the lock rod inside the door has come off.


My Keys wont unlock my cardoor but will lock it It will turn to lock the door but not unlock it?

try turning the key over It could just be that the arm for the lock inside the door has come off, you will need a new retaining clip before you take the door panel off to repair it.


Ford explorer door lock switch wont lock passenger side door?

Lock on driver frot side is not working


Jeep rear door wont close how do you release lock?

Access in rear door panel, allows you to lock/inlock rear door.


How do remove a door handle lock when the lever wont turn?

There should be two screws on the inside of the handle, unscrew them and take the knob apart.


89 maxima electric door lock wont work?

u need to buy a new door lock actuator


How do you reset alarm on 97 jeep with no remote and driver door lock wont work?

You disarm it by unlocking either of the front doors with a key. If that doesn't work, that means that the lock cylinder switch has fallen off of the cylinder. You will have to remove the door panel to reinstall/replace. OR. you could just pop the hood, and diconnect the battery for about a minute


How to replace ignition lock cylinder for 1997 Chevy Malibu if you cant turn the key to ON position the key wont turn at all?

Go to dealer, expensive, have to get one through them so key is the same as the original so you don't need two keys, door/ ignition. Tear apart steering column.


Why wont E250's sliding door lock?

maybe its broken


How can alarm be permanently disabled on a 1995 Chrysler LHS when it wont turn off by unlocking the door?

The factory alarm can not be disabled. If you can not disarm this alarm, the switch on the door key cylinder has failed or is not connected.


Your 1993 acura integra's driver side door wont open as of 4 days ago I think its the lock but can't take your door panel off to take a look inside because the door wont open any suggestions?

as like the key wont turn or the door is just stuck? if so id try a lock smith cuz it might have to be drilled out. if the door is stuck just tug it hard sometimes integra doors bend easily so they dont close right