0
If the engie is in the vehicle a person would have to drain and remove the radiator and water pump the valve covers and valve train ,the intake manifold and associated parts ,the front crankshaft pulley and front timing cover ,the cam gear and chain . also possibly the grill off the vehicle to gain space enoughto remove the camshaft. I t is not a job neccassarily a job to do if a person does not already have the experiance. But the info is available on autozone .com repair info. Not meaning to offend you but it should be left to an experienced mechanic.
What else can I help you with?
Where is camshaft posistion sensor located on 1996 Dodge van 318?
Under the rotor inside the distributor.
How do you install a camshaft position sensor on a 2000 daewoo nubira?
To install a camshaft position sensor on a 2000 Daewoo Nubira, first ensure the engine is off and cool. Locate the camshaft position sensor, typically found near the camshaft on the engine block. Disconnect the electrical connector and remove the mounting bolt(s) to take out the old sensor. Install the new sensor by reversing the process: position it correctly, secure it with bolts, and reconnect the electrical connector.
Can you beef up a 305cu Chevy engine?
install hp cylinderheads and change out the camshaft
How do i install a 1997 dodge caravan 3.0 camshaft position sensor?
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.
How do you install a camshaft seal in a 1988 Plymouth reliant 2.5l?
youtube that sh*t bro haha
How do you install a chevy 350 in a dodge d100?
BIG job,costly. Replace with mopar eng. 318-360.
How do you install a camshaft position sensor on a 2001 Chevy impala?
Are there any videos that show the replacement on replacing camshaft sensor on 2001 chevy impala3.4. Cant find any on youtube, thanks
Where is the camshaft position sensor switch located on your 1995 Durango?
The Dodge Durango was introduced in 1998, so this question cannot be answered. However, in the 2000 Durango.... The camshaft position sensor is located in the distributor on all 3.9L V-6 and 5.2/5.9L V-8 engines Camshaft Position Sensor REMOVAL Distributor removal is not necessary to remove camshaft position sensor Remove air cleaner assembly. Disconnect negative cable from battery. Remove distributor cap from distributor (two screws) Disconnect camshaft position sensor wiring harness from main engine wiring harness. Remove distributor rotor from distributor shaft. Lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor INSTALLATION Install camshaft position sensor to distributor. Align sensor into notch on distributor housing. Connect wiring harness. Install rotor. Install distributor cap. Tighten mounting screws. Install air cleaner assembly. (this info from post on answers.com about cps on 2000 durango)
How do you install oil pick up tube on 318?
Pipe wrench or channel locks right tight left lose
How do you install motor mounts on 1971 Dodge Charger with 318?
you have to jack up the engine one side at a time and replace them.
Can you install lifters the wrong way?
Yes, the bleeder hole has to face up AWAY from the camshaft. If it is down they will not function correctly.
How do you repair a fuel leak on the fuel pump outlet line on a 1996 dodge ram gas 318?
Install a new line.
