You would need to remove the door panel, and disconnect the rods going to the door handle.
The you would need to drill the rivits out of the middle of the door handle.
I have included an instructional video that shows you how to do this, located below.
hi i have a 2001 tacoma and the 2 exterior door handles are broken what tools do i need ??
replacing door handle on a 2001 ford explorer? what tools are needed?
Need to know if it is an inside or outside door handle.
install 99 tail lights and there is no issue.. head over to www.ranger-forums.com for more answers
In a 2001 Ford Ranger the automatic transmission fluid requirements will be indicated on the automatic transmission fluid dipstick or the handle ( Motorcraft MERCON - V according to the Owner Guide )
To change the door handle on a 2001 Ford Ranger, start by removing the door panel by unscrewing any visible screws and gently prying off clips. Once the panel is off, disconnect the power window switch if applicable, then locate the door handle assembly inside the door. Remove the screws or bolts holding the handle in place, disconnect any linkage, and replace it with the new handle. Finally, reassemble the door panel and ensure everything is securely fastened.
It should be in the same compartment as the jack - behind the seat. Agreed. I have a '97 Ford Ranger. The jack and jack handle are in a compartment behind the passenger seat.
how far have you gottan on the dorr glass email me at firehouseint41yahoo.com and i can talk you threw it
The Best Ranger Challenge - 2001 was released on: USA: 12 October 2001
Yes, you can plow snow with a 2001 Ford Ranger, provided it is equipped with the appropriate snow plow attachment. Ensure that the vehicle has the necessary power and weight to handle the plow safely. Additionally, check the truck's suspension and brakes for any required upgrades to handle the added weight and stress of plowing. Always follow manufacturer guidelines for plow installation and use.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
how to replace water pump on 2001 ford ranger