Tools needed: Hex socket driver, wire (2 short pins).
1) Remove the lower trim under the steering wheel.
It is held on by 6 hex screws.
2) Locate the 2 pin socket for alarm programming.
It is under the steering column amongst a thick bundle
of wires. It is an open socket (nothing connected).
Mine was trimmed in yellow/orange.
It has ONLY 2 pins.
3) Turn the ignition switch to Aux/Accessory position.
4) Short the pins in the plug below the steering column
The locks will pulse.
5) Press the "lock" button on each remote.
The locks will pulse each time.
6) Remove the wire shorting the pins.
7) Turn the ignition switch to off.
8) Test the key fobs to lock the doors. They should now work.
To program a key fob for a 2001 Ford Econoline, you'll first need to have two working keys. Insert the first key into the ignition and turn it to the "On" position without starting the engine, then back to "Off." Repeat this process with the second key, and finally, insert the new fob key and turn it to "On." Press any button on the fob, and if done correctly, the locks will cycle to confirm programming.
The key FOB allows the user to open the doors of their vehicle when within a given range. This FOB can be programmed by going to the Ford dealership.
Try Precision Tune
How do you program a key fob to a 2003 Chevy Malibu
To program any kind of key fob you have to take it to a dealership.
How do I re program my key fob for renault laguna estate 1997?
To program a key fob for a 2003 Ford truck, first, sit inside the vehicle with all doors closed. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and then back to "Off" eight times within 10 seconds. The doors should lock and unlock, indicating the vehicle is in programming mode. Finally, press any button on the key fob to program it; the locks will cycle again to confirm programming, and you can program additional fobs if needed.
To add a new key fob, take the vehicle and the key fob to an authorized dealer. To re-program a key fob after replacing it's battery, open the key fob, then read and follow the instructions inside.
To program a 2007 Ford Sport Trac key fob, first, enter the vehicle and close all doors. Next, insert the key into the ignition and turn it from "Off" to "Run" eight times within ten seconds, ending in the "Run" position. The locks should cycle to indicate successful entry into programming mode. Finally, press any button on the new key fob to program it, and the locks will cycle again to confirm successful programming.
http://www.ehow.com/how_7456283_program-key-fob-harley-davidson.html
The key fob programing requires the dealer's scan tool.
It is possible to program one key fob to use on two different cars. If the key fob uses a primitive fixed code system, programming two cars will not work.