answersLogoWhite

0

remove exhaust manifold remove intake manifold remove upper radiator hose remove ground wire at rear of head also the radiator hose bracket at rear of head remove valve cover, position crank and head at top dead center by aligning all arrows up crank up and upper pully on cyl1 and pointing up remove timing belt at this time now remove all 10 cyl. head bolts atarting at the front two now middle of head and work out in 1/4 turn amounts till loose. chears chaz g. sfv !

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove a b2200 Mazda 1990 transmission?

To remove the transmission from a 1990 Mazda B2200, start by disconnecting the battery and draining the transmission fluid. Then, remove the driveshaft by unbolting it from the rear axle and the transmission. Next, detach the transmission mounts, shift linkage, and any electrical connections. Finally, support the transmission with a jack, unbolt it from the engine, and carefully slide it out from under the vehicle.


Where is the fuel pump located on 1990 Mazda b2200?

in the gas tank ?


Where is the location of the water pump on a 1990 Mazda B2200 pickup?

behind the radiator,in the middle of the engine


Is there a 17in chrome spoke wheel to fit a 6x139.7 pattern lowered 1990 B2200 Mazda pickup?

-


Where is the MAP sensor on a 1990 Mazda B2200?

The map sensor is on the air intake line to the throttle body....


Torque specs for head bolts on a 1990 Mazda b2200 pickup truck?

The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).


Can you replace a 1990 Mazda b2600i engine with a 1986 Mazda b2200 engine?

yes you can its a straight swap you don't even have to change engine mounts


What type freon used in a b2200 mazda pickup 1990?

Was built with R12Was built with R12


Where is the blower motor resistor on a 1990 Mazda b2200?

Inside the blower motor housing directly behind the electrical coupler.


Are the 1990 Mazda b2200 series fuel injected?

i own a 1990 fuel injected b2200 they didn't make very many but some of the 90-93 are injected.. finding parts are expensive and used parts for the motor are impossible to find


Where was the 1990 Mazda b2200 truck built?

All the 1986-1993 mazda b series trucks were manufactured in japan.By the way great built trucks for that matter.


Where is the release valve on a 1990 Mazda B2200?

Next to the finiginn pin under the fly cap. A special tool is required to remove the fly cap, available only from the dealer. Ask for a springcock erection tool.