answersLogoWhite

0

To remove the starter from a 2002 Nissan Frontier XE, first disconnect the negative battery terminal to prevent electrical shocks. Then, locate the starter, which is usually found on the driver's side near the transmission. Unbolt the starter by removing the mounting bolts and disconnect the electrical connections, including the power cable and any smaller wires. Finally, carefully pull the starter out from its mounting position.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

How do you remove the spark plug for a Nissan frontier 2007?

The Nissan frontier would most likely have their spark plugs down deeper into separate chambers. If it is anything like new ford model trucks you have to locate the wires covering them, about an 8 in extention and a 5/8 in spark plug socket.


Where can one purchase a Toyota Frontier?

Nissan, not Toyota, manufactures a Frontier model vehicle, which is a light truck. It may be purchased directly from a Nissan dealer. A Frontier may also be purchased from automobile and truck resale businesses such as Carmax.


Is 6000 too much for a Nissan Frontier with 151000 miles?

Depends on the model year of this Nissan. More information required, please.


What size socket do you need for the oil drain plug on a 2013 Nissan Frontier?

For a 2013 Nissan Frontier, you typically need a 14mm socket to remove the oil drain plug. However, it's always a good idea to double-check with your vehicle's manual or inspect the plug directly, as variations can occur based on the specific engine model.


How do you change the starter on a 1994 Nissan Pathfinder?

disconnect neg batt cable, raise front of vehicle on jack stands, remove wiring from starter, remove 2 retaining bolts on starter attached to passenger side where transmission meets engine, lower starter. install in reverse order.remember, you must disconnect the motor mounts and lift the motor to gain enough clearance to remove the starter. on 94 4x4 se model. I just performed this task.


Is there a difference between a starter from a manual transmission 1995 Nissan 200sx S model and a starter from an automatic transmission 1996 Nissan 200sx SE model?

YES ... you don't even have to read to much into the book to find out either ... It says it on the cover of the manual it's for a 1996 Nissan 200sx ES ...


How do you replace the starter in a 1997 Nissan Altima GXE?

Disconnect the battery terminals raise the car up block the tires and lower onto jack stands. Disconnect the solenoid connector and the harness from the starter remove the starter bolts from the transmission bellhousing and remove the starter. Simple as that . depending on the make and model year you may have to turn the steering whell to get better access. Installion is the same in reverse. Bryan


What are the torque specs for a yd 25 Nissan engine?

what is the torque specs for a y d 25 2004 model nissan frontier main bearing and rods on engine


What should the fuel mileage be on a Nissan Frontier?

it's dependent on the year and model but typically around 20 mpg highway


How fast can a 2008 4.0 v6 Nissan frontier go?

A Crew-Cab SE model will do 112mph in stock configuration.


What transmission will interchange with a 1999 Nissan Frontier 4x4 4cyl manual transmission?

only a 1998 will interchange with that year model


Where is the expansion valve on a 2002 Nissan Frontier?

The expansion valve on a 2002 Nissan Frontier is typically located in the engine compartment, near the firewall, and is part of the vehicle's air conditioning system. It is usually situated between the evaporator and the condenser. To access it, you may need to remove components like the dashboard or certain panels, as it can be somewhat hidden. Always refer to a repair manual for detailed guidance specific to your model.