To remove the connector plug on a passenger airbag, first ensure that the vehicle's ignition is off and disconnect the negative battery terminal to prevent accidental deployment. Locate the airbag connector, usually found beneath the dashboard or in the glove compartment, and gently press the release tab or lever on the connector. Carefully pull the connector apart, taking care not to damage any wires or components. Always follow safety precautions and consult the vehicle's service manual for specific instructions.
In a Chevy Avalanche, the horn connector is typically located behind the steering wheel. To access it, you may need to remove the airbag and the steering wheel cover. The connector itself is usually a plug that connects the horn wire to the steering wheel assembly. Always ensure you take proper safety precautions when working with airbag components.
It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.
Under the passenger seat, facing forward. Its a pre OBD connector.
Try some switch-cleaner on the yellow connecting plug under the passenger seat!
Cyl #3 is right side (passenger side) head 2nd one back from front. Right head cyl # is 1,3,5,7 and left is 2,4,6,8. Remove the valve cover and the connector to the glow plug. Using a 10mm deep socket and wrench loosen and remove. Install new one and reassemble. Don't forget to connect the one wire connector to the plug before putting the valve cover back on.
Above the passenger side footwell you will find a white connector with 4 wires. Disconnect the plug, remove the two small hex-head screws and you can remove the fan motor resistor. It is poorly made and may be corroded or burnt out, but it is certainly easy to remove and replace.
I found an adapter of the Silverado plug connector at the local U-Haul Store.
its actually illegal to disable active airbags. but if you hav to, disconnect the batt negative terminal than simply unplug the yellow plug under the dash at the airbag. it may cause the light to come on.
The OBD II connector is under the ashtray. Remove the ashtray and slide the plastic cover to the left and the connector will be visible.
Diagnostic plug. Diagnostic connector. Data link connector.
on the passenger side below the glove box door is the obd2 connector.
You have to remove the glove compartment (not sure on how many bolts, its been a while), once it is removed you can see 2 12mm or 14mm bolts that have to be removed. You can't miss these bolts as they are a gold color. Once those bolts are removed you can slide the passenger air bag out some. Next you have to remove the plug from the side of it. It is on the passenger side of the actual airbag and it is a single wire plug into the side of it. Once that is removed you can take it all the way out. The installation is the opposite of the directions that I have provided. Good luck, as that one wire plug can be hard to take out.