To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
Open the cup holder and remove the two screws on the outside.
Remove original ashtray, remove 4 screws that hold ashtray mounting bracket. This will give access to the 2 screws that hold inner end of cup holder. The cup holder must be pulled all the way out to get to screws. Remove screws, remove 2 screws in front face, cup holder will come right out. Installed updated cup holder in 20 minutes, start to finish!
Pull the cup holder out. Reach back, and at the top rear, center-left, is a tab. Press the tab down and pull out on the cup holder to remove it.
I cannot find how to remove the cup holder from the dash of my 2001 Pontiac Montana
To remove the cup holder in a 1998 Toyota 4Runner, start by prying off the plastic trim surrounding the cup holder carefully to avoid breaking clips. Once the trim is removed, locate the screws or bolts securing the cup holder in place and remove them. Gently pull the cup holder out of its slot. If it's stubborn, ensure there are no hidden fasteners and use a flat tool to assist in prying it out.
To remove the cup holder from a 2005 Acura RL, start by using a flathead screwdriver to gently pry off the trim panel surrounding the cup holder. Once the trim is removed, locate the screws or clips securing the cup holder in place and remove them. Carefully pull the cup holder out of its housing, ensuring not to damage any surrounding components. Reassemble by following the steps in reverse order.
To remove the rear cup holder from a 2005 VW Beetle, start by gently prying off the trim panel surrounding the cup holder using a flathead screwdriver or a trim removal tool. Once the panel is removed, look for screws or clips securing the cup holder in place and remove them. After that, you can pull the cup holder out of its housing. Be careful not to damage any surrounding components during the removal process.
Very carefully(;
Take it out
Remove ashtray if equipped, push cup holder in slightly and hold down on the plastic lever at the rear left side of ashtray slot while pulling out the cup holder. Least that's how to remove it on a 1999 T&C Limited.
The cup holder in a Dodge Ram has four bolts, and two bolts above those bolts. You will need to unscrew all six bolts and then the cup holder drops off.