The bearings is press fit. The 'cold chisel' method is an option, but then you risk damaging the shaft, causing oil leaks. Best way is to send in the shaft with new bearing to a shop with press, and let them do it. The charge is usually nominal and saves you hours of frustration.
To stop an oil leak at the rear wheel bearings of a Nissan 1400 bakkie, first, ensure the vehicle is safely elevated and supported. Remove the wheel and brake components to access the rear hub. Inspect the wheel bearing seal for damage; if it's worn or damaged, replace it with a new one. Finally, reassemble the components and check for leaks after adding lubricant to the bearings.
how do you replace rear wheel bearings on nissan pulsar
How do you replace the front wheel bearings on a nissan frontier 4x4 1999
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
Can figure out how to remove rear rotor assembly to replace wheel bearing assembly on a Maxima 2004 Nissan
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.
How to remove rear wheel bearings on a 1978 corvette..?
Remove the tire and wheel from your 2003 Kia. Remove the axle end. Remove the wheel bearing retaining nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearings.
pop them out of the wheel
To properly repack the wheel bearings on a bike, first remove the wheel from the bike. Then, take off the axle and remove the bearings. Clean the bearings and inspect them for wear. Apply fresh grease to the bearings and reassemble them in the wheel hub. Finally, reinstall the axle and adjust the bearings to the correct tightness before putting the wheel back on the bike.
You can not greas the rear wheel bearing on Nissan Vanette openly. You have to dismantle the axle completly.