To remove the door panels on a 2002 Mitsubishi Montero, start by carefully prying off any trim pieces or covers that hide screws, typically located around the door handle and armrest. Next, remove the screws using a screwdriver and carefully lift the door panel away from the door frame, starting at the bottom and working your way up. Disconnect any electrical connectors, such as those for power windows or locks, before fully detaching the panel. Once the panel is off, you can access the window motor for repair or replacement.
Dealer? Salvage Yard?
You can remove the panels from the doors of the 1997 Mitsubishi Colt 1.3 GLX by first removing the screws from the door handles. Then, pry the panel away from the frame using a flat tool like a chisel or a screwdriver.
Relay switch in door is bad, replace relay switch. Remove interior door panel and you will find relay switch.
inside the doors. you have to remove the inside door panels
Need to know how to remove the interior door panel so I can replace motor for electric window
To replace the rear quarter window on a 1994 Ford Explorer, first, remove any trim or panels covering the window area. Use a suitable tool to carefully cut away the old adhesive around the window, then gently remove the glass. Clean the surface where the new window will be installed, apply new adhesive, and carefully position the new window into place, ensuring it seals properly. Finally, reinstall the trim or panels to complete the job.
Just remove sidings from the door (inside), then remove all bolts you will see, i think 6 pcs. then you can easily figure it out how you will remove the motor from the door shell.
7
A sash window is a window that has at least two separate panels of glass. Doesn't matter if one of them slides or tips or tilts to open up the window, the minimum requirement is simply 2 panels of glass.
Rear window relay is inside the pillar on drivers side - its easiest if you remove th rear passenger interior side panels
remove the screw in the inside handle then pop out the plastic piece and remove the screw inside there (big torx bit) remove any other visible screws and pop off the panels retainer clips, disconnect the power lock and window wires.
marshall's