Under top engine cover that says 32 valve Northstar between both cylinder heads. Good luck
remove right valve cover on cadilac sts
where is the starter motor located on a 1995 northstar and can it be removed without much trouble Its under the intake manifold on the driver side. just remove the intake cover, then the upper intake and there it is. good luck.
Front are easy to access, rear is the same but very tight. Remove plastic engine cover. The Northstar engine uses a coil pack that is directly over the spark plugs. It is right up front on top of the engine. It is held on by approx. 9 screws. Unscrew these and unplug the coilpack. spark plugs are located in the four holes in front of you. Same for rear of engine, just a little harder to get to.
The 2000 to 2002 Northstar motors should be the same in this perspective. First you need to remove the cover over the intake manifold. it should have 2 plastic nuts. for the front side, the ignition coil is visible and can be removed with 8 bolts and unplugging a pigtail. It sits directly on top of the Valve cover. Then you'll need to remove the boots that sit on top of the spark plugs. The rear is the same except you'll need to remove a few brackets for components that will be in your way.
I FEEL FOR YOU LOOK THIS IS A VERY EASY TASK IT TAKES 30-45 MIN 1. MAKE SURE THE ENGINE IS COLD ALLOW IT TO SIT OVERNIGHT IF NECESSARY 2. REMOVE ENGINE COVER AND SET ASIDE 3. REMOVE THE IGNITION COIL CASSETTES 4. REMOVE SPARK PLUG BOOTS 5. REMOVE SPARKPLUGS FROM CYLINDER HEADS 6. GAP NEW PLUGS TO 1.27mm (0.050in) 7. TORQUE NEW PLUGS TO 15 FT/LBS 8. REVERSE PROCEDURES TO REASSEMBLE OH AND BY THE WAY I WOULD USE IRRIDIUM PLUGS THEY COST ABOUT $12.00 EACH BUT YOU WILL NOTICE THE PERFORMANCE DIFFERENCE IN THAT BADA@$ NORTHSTAR ENGINE
its located under the engine cover in between the heads
I'm going to assume that it is similar to the cover on the 1997 Deville Concours. In the '97 you simply 'pull up' on the cover. It has prongs that press and snap into receiver ports in the vehicle proper.
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
Remove the decorative radio cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness from the back of the radio.
On the North Star engine you need to remove the air filter assembly and look on the right side of the engine you will notice the thermostat housing connected to the water pump cover on the engine. Once the water pump cover is removed a special socket is needed to remove the water pump. It is also a good idea or install a new belt on the water pump as well.
Right side under dashboard. Remove plastic cover then look for a Round plastic cover.